Re: Hub Shark Users

John S. Lagnese jlagnese at
Mon Oct 27 19:21:54 PDT 2008

It most likely leaves space for the whole apparatus. My hub kit needed room 
on the inside of the hub.
----- Original Message ----- 
From: <kneale at>
To: "20valveList" <200q20v at>
Cc: "V8List" <v8 at>
Sent: Monday, October 27, 2008 6:31 PM
Subject: Hub Shark Users

> I'm preparing for my first use of a Hub Shark to replace a wheel bearing
> on my 200q20vA.  I've removed the UFO caliper and the axle.  The Hub Shark
> directions say to disconnect the lower control arm, but I presume that's
> to make it possible to swing the bearing housing away from the axle so you
> don't have to pull the axle.  Since I've already pulled the axle, is there
> any reason to also disconnect the lower control arm?
> _______________________________________________
> 200q20v mailing list
> _______________________________________
> No viruses found in this incoming message
> Scanned by iolo AntiVirus

No viruses found in this outgoing message
Scanned by iolo AntiVirus

More information about the 200q20v mailing list