Hub Shark Adventure Story
frank j. bauer
frankbauer at thevine.net
Tue Oct 28 15:33:46 PDT 2008
i think there's a c-clip that goes in before you press in the hub - did
you remember that?
or maybe that's only on the earlier models...
kneale at knitknacks.com wrote:
> I got my 200q20v's wheel bearing out and back in and then foolishly
> pressed in the hub without backing the center of the bearing=one ruint
> bearing. Next one went in a little less hapily, but I also got the hub
> pressed back in without destroying the binding. Just a $40 lesson, I
> guess. Anyway, anybody know how big a gap there should be between the hub
> and the bearing housing? I have about a 4mm gap. I didn't measure
> before, the bearing is against its shoulder and the hub end is at the
> inner bearing surface, but the gap just looks larger to me.
More information about the 200q20v