Half Shafts - Dimension?
ybk at dongames.net
Mon Jan 19 10:36:00 PST 2009
Stripped inboard splines while driving uphill on ice and snow under full power in TO facility last January. This is after several years doing exactly the same every winter school.
From: Bernie Benz <b.benz at charter.net>
Date: Monday, Jan 19, 2009 1:11 pm
Subject: Re: Half Shafts - Dimension?
To: YBK <ybk at dongames.net>
CC: 200q20V mailing list <200q20v at audifans.com>
Really! Shaft failed? Shaft broke in two, or stripped the inboard
spline? Tell more!
On Jan 19, 2009, at 9:53 AM, YBK wrote:
> Please stop being unreasonable.
> The shafts do fail. Mine failed on INNER side and I left with zero
> wheel drive. I had to purchase a used shaft with inner join and
> reuse my outer.
> -----Original Message-----
> From: Bernie Benz <b.benz at charter.net>
> Date: Sunday, Jan 18, 2009 10:17 pm
> Subject: Re: Half Shafts - Dimension?
> To: "Gary Anderson" <wanemardo at comcast.net>
> CC: 200q20V mailing list <200q20v at audifans.com>
> Was your new shaft an exchange shaft assembly, in which the new shaft
> is not your old shaft? Why, Oh why would you risk such a swap?
> Shafts dont wear out! Inner CVs dont wear out! Outer CVs seldom
> wear out, short of long term boot failure. Did you really need
> anything more than a new boot? You are asking for a dimension
> including the spline slip variable distance. Huh!
> Next time use this great resource, dont just lurk! And DIY.
> On Jan 18, 2009, at 6:20 PM, Gary Anderson wrote:
>> A short note from one of the lurkers here.
>> Just had a left front half shaft rebuilt at a local area driveline
>> shop, new
>> joints & boots at both ends.
>> Seems cores half shafts for our 200-20v cars are not readily
>> Ours are rebuildable if you provide yours as a core, joint parts
>> are catalog
>> Installation isn't going so well, seems I cannot get the ball joint
>> lined up with the strut housing to make the lower connection.
>> I appears to be about half the stud diameter, or about 1/4"-3/8"
>> The half shaft is tight, and as compressed as much as I can make it
>> a BFH treatment.
>> My present thinking is (for some reason) the rebuilt half shaft is
>> longer than original length.
>> So here's my question (if anyone has a spare) .
>> How long is a half shaft, overall from the spline end to the inside
>> end of
>> the inner flange/joint surface, where it mated up to the differential
>> I measure my rebuilt one at approx 24 1/8" for a reference.
>> Any thoughts on-line or off line appreciated.
>> Thanks in advance, Gary A.
>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
More information about the 200q20v