Re. Loose ball bearings by flywheel?
benswann at verizon.net
Mon Sep 28 18:47:46 PDT 2009
It sounds like you had the same thing happen as I had a few years back. Essentially the
clutch release bearing (aka throwaout bearing) disintegrated. The shrapnel took out one
or more pins with it. After the tow home, I took the opportunity presented to replace
clutch, disk, pressure plate, resurface flywheel, and slave cylinder, among assundry
other cleanup and improvement tasks. I decided to pull the engine, since there were
more "opportunities" by doing it this way. Those included, new turbo, wiring cleanup,
and a good engine going over - timing belt, etc.
Had the car needed suspension work that I had already completed, I would have likely
dropped the trans instead. Six one way - half dozen the other.
Have fun and address all the things now you don't want to go back and do later, and then
some for good measure.
[Date: Sun, 27 Sep 2009 17:43:33 -0400
From: Mike <xthejuicex at gmail.com>
Subject: Loose ball bearings by flywheel?
To: 200q20v at audifans.com
<592a96020909271443v245e5013i70d1810ef51b12da at mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
Hey everyone. I was checking out to see if the cps pin on my flywheel was broken and
when I pulled out the starter to look through the hole at the flywheel, these small
metal balls came out. They had grease on them and when I poked around inside i could see
and feel some small sharp pieces of metal.
Did some bearing explode or something? Here is a pic of the balls and are next to a
lighter for reference. http://i38.tinypic.com/2yum6md.jpg . BTW the car won't start but
would crank over and get fuel.
More information about the 200q20v