[ba] replacing sub frame bushings

Chris Maresca ckm at crust.net
Tue Aug 19 06:20:32 EDT 2003

Delrin is fine, but I've had issues with both cracked lower a-arms and


On Mon, 18 Aug 2003, Wyatt's Dad's Audi wrote:

> On Monday, August 18, 2003, at 08:50 AM, JShadzi at aol.com wrote:
> > When I did Delrin bushings in my car, my initial thought was
> > that the improvement was similar to when I did the coil over
> > suspension on the
> > car, in other words, dramatic.  The stock control arm bushings are a
> > huge
> > performance compromise from the factory, the Delrins make up for this
> > with the side
> > affects mentioned above.
> Javad,
> Do you know of a good source for the Delrin bushings? And even the
> stock type?
> Also, next time I'm down the peninsula can I look you up for a short
> ride to feel what it's like? I'm pretty happy with the current handling
> since I have a couple of motorcycles to get the super-tight handling
> stuff out of my system but if the Delrin isn't too much more than the
> stock stuff and the work is the same then it's worth my looking into.
> Is there any step in between stock and Delrin?
> Thanks,
> M./
> _______________________________________________
> Audifans ba-group mailing list
> Send posts to: mailto:ba-group at audifans.com
> Unsubscribe or Manage your list options: http://www.audifans.com/mailman/listinfo/ba-group
> Have an Audi question?  Look for your answer in the Audifans Knowledgebase!
> http://www.audi-quattro.org/kb ... all contributions welcome!

chris maresca
      senior partner - www.olliancegroup.com

linux, up 126 days

More information about the Ba-group mailing list