[Es2] BPV interferance

Ben Klumper bklumper at mdbworld.com
Mon Dec 8 11:12:22 EST 2003

Hey guys,

ETKA shows how the BPV is re-routed with an albow and a section of rubber
hose. I've managed to get my hands on these parts, so it should work out.
The sheet metal surrounding the headlamp is pretty crucial because it has
the spring for the hood release running down the side exactly where it
interferes with the BPV, so I don't think the dremmel can be used.


----- Original Message ----- 
From: "Peter Schulz" <peschulz at cisco.com>
To: "Matt twentyV" <matt_20v at yahoo.com>
Cc: "eS2 List" <es2 at audifans.com>
Sent: Monday, December 08, 2003 8:59 AM
Subject: Re: [Es2] Hard day at the office...

> Guys:
> I'll try to take a picture of the one on my S2 (UK 3b Engine) and send it
> I recall that its different than the 200s....
> -Peter
> >> 2) The bypass valve on the turbo inlet hose severely
> >> interferes with the right side lock carrier/rad
> >> support. I
> >
> >Mine too.  Very (very) crowded behind the pass.
> >headlight.  I just have mine packed in there, it is
> >rubbing on the metal.  I think judicious use of a
> >dremel could eliminate the interference but haven't
> >gotten that far yet.  Interested to hear how others
> >tackle this.
> >
> >-Matt
> Peter Schulz
> 1990 CQ (awaiting S2 3b engine transplant)
> 1991 200 20v TQW indigo mica
> 1991 200 20v TQW titanium grey
> Chelmsford, MA USA
> peter at audifans.com
> _______________________________________________
> Es2 mailing list
> Es2 at audifans.com
> http://www.audifans.com/mailman/listinfo/es2

More information about the Es2 mailing list