[Es2] fuel rail comparo, weight trivia, etc.

Jimmy Pribble Jimmy at texasbankers.com
Thu Mar 18 16:05:59 EST 2004

Jack, I hope you don't mind a public response, but my reply to you bounced
for some reason.  Cheers!

-----Original Message-----
From: Jimmy Pribble 
Sent: Thursday, March 18, 2004 2:35 PM
To: 'Jack Walker'
Subject: RE: [Es2] fuel rail comparo, weight trivia, etc.

Hey Jack,

Thanks for the kind comments!  My buddy (and primary mechanic) Ken Fluhr did
the polishing.  Though he did an outstanding job, it's really just a matter
of elbow grease and patience, there isn't any magic to it.  Power tools will
certainly lighten the load, but it's as simple as polishing with heavy grit,
then lighter grit, then even lighter grit, then fine grit, then micro grit,
then finish with your favorite polishing compound (we used Mother's).  It
takes a lot of time (even with power tools), but the results are worth it,

No, we didn't extrude hone, ceramic coat, or powder coat anything.  That
decision was mostly financial, rather than performance based.

Good luck with your conversion!


More information about the Es2 mailing list