[Es2] Big Brakes
andrews at columbus.rr.com
Fri Nov 19 11:46:29 EST 2004
Thanks for the input i was looking at the ECS website and i think ill give
them a call this afternoon. There somewhat local to me which is nice too.
The wiring is going well so far on the car. The engine side of the harness
is close to completion next is the interior part of the harness and the
start up :) Looking forward to driving the coupe again after driving the
Avants for two years.
From: C1J1Miller at aol.com [mailto:C1J1Miller at aol.com]
Sent: Friday, November 19, 2004 9:01 AM
To: "Andy Suttner"; es2 at audifans.com
Subject: Re: [Es2] Big Brakes
In a message dated 11/19/2004 1:18:22 AM Eastern Standard Time, "Andy
Suttner" <andrews at columbus.rr.com> writes:
>Just checking around for a big brake kit/parts. Was going to do a kit with
>the four bolt wheels but an issue came up and that will no longer happen.
>Now I'm searching around for a kit for the coupe with 5 bolt wheels. What
>solutions did you guys use? I have the RS2 caliper brackets for building a
>kit myself. Where did you guys get the set ups? What kind of prices should
>expect? I see most kits go for about $2000. TIA
My coupe has the S2 5-bolt hubs. I used the RS2 brackets to mount my 2000
Porsche Carrera calipers, over euro 314x30 A8 rotors. Barely fits in my 16"
urS4 5-spoke wheels; really more brakes than you need. You should also
change the brake proportioning valve to fix the bias if you add
I'm in Massachusetts; you're welcome to see the car/test fit wheels.
More information about the Es2