[Es2] used s2 hubs

Kenneth Keith auditude at gmail.com
Sat Feb 26 13:12:45 EST 2005

Elijah, does that mean you're gonna go with the localish Impex rear
hub that Peter mentioned?  I just read your S2forum post about getting
some rear hubs shipped over.

I think there's a guy I know with an extra set of front urS6 hubs, and
I'll try to get those.  Actually, does anyone know if a 200q20v hub
would work?  I might have access to a pair of those.

So I guess the relationship between the wheel bearing and the G60
mount are the same between Scars and CQ/S2's?

Is there an oem rotor that lines up correctly with a 996 caliper on an
RS2 bracket if I use an urScar hub?  It sounds like euro A8 works with
the S2 hub.  Can or must the bracket be shimmed to center the caliper?

What I'm looking for is to combine the less expensive DIY big brake
solutions that use the RS2 brackets, since I have those, and some
urScar hubs that I might have access to.  I can get some used Porsche
calipers and try to keep the cost down.



On Fri, 25 Feb 2005 16:29:40 EST, Elijahallen92 at aol.com
<Elijahallen92 at aol.com> wrote:
> Ken,
>  S4/S6 hubs work up front and then you can use any of the many front brake
> upgrades out there for the urs cars. This is what I did and swapped my ECS
> stage 3 setup onto the coupe from my crashed S4.
> Elijah
> Peter,
> Wow!  Really?  Is that the same hub as the rear of a 2002+ A4q, which
> I heard shares the same brake rotors as an S2?
> That's sweet!  That means maybe I'll only have to pay for the e$oteric
> front ones.
> Hmm, now that I think about it, it's not as huge of a savings as I
> assumed.  At $700 from europarts for all four, this one is at $290 for
> (perhaps the cheaper/smaller) half.  Even so, money savings is money
> savings!  =D
> Thanks,
> Ken

More information about the Es2 mailing list