[Es2] my project

David Kase davekase at pdqlocks.com
Wed Jan 12 07:32:09 EST 2005

Hey Rick,
What location  re you using for the hole to run the harness through?  I 
have an S2 harness and I need to find out where the S2 hole would be.  I 
assume your hole is custom as you removed the harness yourself (unless 
you were in Europe dismantling an S2 four years ago).


Rick Houck wrote:

>As Darin says, chatter is light, so I will chime in.
>I spent the last two weekends installing the 3B into my 47k mile project
>coupe . I was starting from almost a bare shell, so I had to install
>everything. Fuel lines went bad just sitting around, even though it has been
>stored inside. I ran new feed and return tubes from fuel filter to engine,
>and adapted to the engine. I used one of the coupe braided hoses to make a
>neater installation.
>I bought new clutch master and slave cylinders and new tranny and engine
>mounts. Figured there will never be an easier time to do these.
>I cut the holes through the firewall, and pulled the harness and battery
>cable through. I installed the entire driveline (except front half shafts)
>including engine and tranny, rear dif, axles, and drive shaft, and routed
>all the underhood wires and hoses to the proper connections. It was nice to
>remove the tags that have been on the harness since I pulled it from the
>donor four years ago. Still need to connect the MAF and canister, and a
>tranny connection. Alternator and coolant pump will come later.
>My job now is to connect the wiring behind the firewall. This, I fear, will
>be the biggest pain of all. Wish me luck.
>Rick in Ohio
>coupe of the big steps finally done
>Es2 mailing list
>Es2 at audifans.com

More information about the Es2 mailing list