[Es2] Compatibility of URS4 clutch and flywheel

Elijahallen92 at aol.com Elijahallen92 at aol.com
Fri Mar 4 13:27:24 EST 2005

In a message dated 3/4/2005 1:23:14 PM Eastern Standard Time,  
Hull at cardinalpartners.com writes:

I  believe the flywheel for the AAN is a dual mass design that makes for
a  thicker assembly than the 7A.  I believe almost everyone has used  the
CQ flywheel and various clutch solutions.  In my case, I have the  CQ
flywheel which was lightened 5-6lbs, the CQ pressure plate and an  RS2
clutch disk.  (trans is RS2 six speed)  This has been fine  for 35K
I still have an RS2 flywheel and pressure plate if anyone  wanted to buy


 My S4 engine had a 11lb aluminum flywheel and centerforce clutch. I'm  just 
worried because the Canada guys put it together with the stock tranny and I  
don't know if it will be fine or not. Any idea or should I pull the tranny off  
to inspect it?


More information about the Es2 mailing list