[Es2] 3b engine pull

Dave Hord dhord at rogers.blackberry.net
Fri Feb 2 12:02:36 EST 2007

I've always been able to attach the engine hoist to the engine before sliding it off the tranny, so there is _something_ fairly obvious on the block back by the bell-housing. At least, I think!

I do know I've always had to be careful the chain I used clears the distributor...so that might give you a bit of geography and where to look 


-----Original Message-----
From: Ben Klumper <bklumper at mdbworld.com>
Date: Fri, 02 Feb 2007 08:53:04 
To:Dan Daunais <dandaunais at gmail.com>, es2 at audifans.com
Subject: Re: [Es2] 3b engine pull

I've always connected the hoist to one of the block-to-transmission bolts.


Ben Klumper, Architect AAA
McKinley Dang Burkart Design Group + Eleven Eleven Architecture
103, 1111-11th Avenue S.W.
Calgary, Alberta
T2R 0G5
p. 403.229.2037 e.231
f.  403.229.2517

----- Original Message ----- 
From: "Dan Daunais" <dandaunais at gmail.com>
To: <es2 at audifans.com>
Sent: Friday, February 02, 2007 8:20 AM
Subject: [Es2] 3b engine pull

> Hi guys,
>  I am just starting my conversion and will be pulling the engine from my
> 200tq tomorrow.  Just a quick question on the pull itself - the connection
> in the front is cake, but where have you all connected the hoist in the
> back?  If there's no good anchor in the back I was thinking of just 
> wrapping
> some tow straps underneath and connecting that to the leveler.
>  Any info is appreciated.  Thanks!
> -Dan
> _______________________________________________
> Es2 mailing list
> Es2 at audifans.com
> http://www.audifans.com/mailman/listinfo/es2

Es2 mailing list
Es2 at audifans.com

More information about the Es2 mailing list