[Es2] ES2 conversion - AAN in '90 CQ AC using serp belt setup ?

Ben Swann benswann at verizon.net
Fri Feb 13 12:17:29 PST 2009

Does anyuone know of similar fabrication place for doing a custom AC condenser/radiator?

-----Original Message-----
From: Kenneth Keith [mailto:auditude at gmail.com] 
Sent: Thursday, February 12, 2009 5:59 PM
To: Ben Swann
Cc: Mark J. Besso; es2 at audifans.com; quattro at audifans.com
Subject: Re: [Es2] ES2 conversion - AAN in '90 CQ AC using serp belt setup ?


This is one of the places that does that type of thing:


I got an 034 aluminum radiator and it was made by Ron Davis.



On Thu, Feb 12, 2009 at 2:17 PM, Ben Swann <benswann at verizon.net> wrote:
> I like the serp. belt layout - looks good and leaves plenty of room on the turbo side.
> the problem is that the mounting bracket sticks too far out from the 
> block and also the AC lines will likely interfer and I think it is 
> tight for the alternator connection as well.
> The only alternative I can see to retain the serp. configuration is to 
> have a narrow radiator fabricated and narrow AC condensor.  I can always run an aux
> Is there a company that can fabricate  custom radiator based on given 
> dimensions and hose locations.  Same with AC condensor?
> Ben

More information about the Es2 mailing list