[Marketplace] Parts: 2000-01 S4 APB 2.7T 6MT Longbloc

A4Rob marketbot at audifans.com
Fri Dec 19 10:45:22 PST 2008

Section:  Parts
Title:    2000-01 S4 APB 2.7T 6MT Longbloc
Price:    1,200.00
Location: Minneapolis

Date:     November 02, 2007
Contact:  A4Rob
Email:    rob at ap-specialties.com
Phone:    763 479 5333


This listing is for a 2.7L twin turbo (biturbo) 30v DOHC V6 out of a Audi S4. It will bolt into a 2000-2001.5 S4, or a 2000-2002 A6, either with the 6-speed manual transmission. This motor had 96k on it when pulled from a wrecked car, and a compression test shows 180 to 185psi on all cylinders.

The following parts are included:
-Complete base longblock with oil pan, block, crankshaft, rods, pistons, head, camshafts, timing sprockets, and valve covers
-Intake Manifold
-Exhaust Manifolds
-Both stock K03 turbos, with a moderate amount of shaft play
-All turbo coolant and oil lines intact
-Stock dual mass flywheel
-Stock-style clutch
-Engine harness and a full array of sensors including EGT probes and O2 sensors--Some damage, see below
-Stock fuel rail and injectors

Parts not included:
-Throttle Body
-Turbo Inlet Hoses/Pipes
-Mass Air Flow Sensor
-Coil Packs
-Power Steering Pump
-AC Compressor
-Timing Belt Covers
-Front Lower Coolant Pipe

We do have some of these items available for sale separately, contact us if interested through Audizine PM/message or at audi-parts at ap-specialties.com.

There are a couple of sensor leads and connectors on the harness that have been damaged. These could be repaired easily, there are just a couple of connectors that have been smashed/broken, however, you will not be able to plug the harness into a car as-is and have it fully work. We can include replacement connector pigtails for no cost, or repair the harness with new pins and connectors for a moderate cost.

This motor is ideal for replacing a blown motor, swapping into a project car, or for using as a parts engine. The longblock is in good, solid condition. The turbos are in useable condition, but because of the labor involved in replacing them, we would recommend installing new ones before use.

This motor will have to be freighted unless local to the Minneapolis/St. Paul area. Truck freight to a commercial address with a loading dock or forklift runs around $350-$450 depending on location. Residential delivery is typically $75-100 more, our cost as charged by the freight company.
Thanks for browsing!


[  This is an automated message    ]
[  You are receiving this message  ]
[  because you signed up for the   ]
[  Marketplace email notification. ]

More information about the Marketplace mailing list