[200q20v] door lock repair...update

Phil Rose pjrose at frontiernet.net
Fri Oct 20 19:00:50 EDT 2000

At 12:41 PM -0400 10/13/00, Phil Rose wrote:
>  I discovered that this screw had
>pushed against the plastic tab holding the screw-anchor (an integral part
>of the door panel) and had broken the tab off!
>So, now the door lever release works OK, but since there's no no place  to
>secure it (using that screw), the entire lever housing will easily slide
>forward and pop out of the door panel.   :-(  Am I the only fool who's done
>this? IF not, have any of you _others_  come up with a way to keep this
>assembly in place? I have retrieved the broken anchor tab and am
>considering the possibility of using an epoxy putty to re-attach it. Other
>ideas welcome.

Following Al Powell's advice, I reattached that broken-off piece using
"Devcon Plastic Welder". This adhesive is a scarce item around here, but
was available in Wal-Mart. It is a two-part modified epoxy; it sets up very
quickly (within a few minutes) and seems to have sufficient strength. I
don't know the plastic type (ABS?) that's used for the door trim panel, but
the "Plastic Welder" seems to form a very good bond with it.

*  Phil & Judy Rose           Rochester, NY  *
*        mailto:pjrose at frontiernet.net       *


More information about the quattro mailing list