Header Sealing Washer Suggestions?

JShadzi at aol.com JShadzi at aol.com
Fri Dec 13 13:50:49 EST 2002

>I was installing a tubular header in the NF engine I've been prepared.

Wow, not many of those around, for normally aspirated I'm assuming?

>I have a set of OE seal washers, but when I tried to use them with my header
>they were not visually sealing properly. The header stud holes are different
>than the stock EM. They seem to be a bit bigger.

Do you have a picture of the flanges?  Its tough to say, but if the header was build for a 10v motor then any of the gaskets should work.  Also, there are two size gaskets, laster gaskets for the crossflow VW's are much bigger, that 's what  I used, but I built the head and header around those gaskets, maybe you've gotten a set of those by accident?


More information about the quattro mailing list