In-situ flywheel timing pin replacement
Joshua Van Tol
josh at spiny.com
Mon Dec 23 13:18:50 EST 2002
On Monday, December 23, 2002, at 11:27 AM, Jpinkowish at aol.com wrote:
> In a message dated 12/23/02 12:19:53 PM EST, ackramer at hotmail.com
>> epoxy a roll pin to the pin stub and shim the
>> sensor back by the thickness of the roll pin.
> how about using J-B Weld or Loctite Cold Weld instead of the epoxy?
Don't know about the loctite stuff, but jb weld is just metal loaded
epoxy. Pretty good metal loaded epoxy, but not unique.
More information about the quattro