1990 Audi 100 ignition switch replacement

Dennis Larson dennisl at mr.net
Fri Apr 9 13:44:56 EDT 2004

I am replacing a defective ignition switch on 1990 Audi 100. The problem is getting the last detail completed before removable. Here is where I am at so far.

Air bag removed/disarmed.

Steering wheel removed.

Panel removed.

Cover under the panel removed.

The tamper-proof torx screw also removed.

Now I am getting close to remove the assembly so I can remove the switch from the back and fit the new one on.

Rather than flail around, now it time to ask where I go from here. Is there yet another screw or pin to punch out behind the tamper-proof torx screw, this was the one I had to drill out to get the torx socket into it.

Or do I tap out the ignition/lock assembly sideways?



1990 Audi 100

More information about the quattro mailing list