89 Audi 200 Turbo starter

Alan Pritchard apritchard at seaeye.com
Wed Nov 3 10:57:47 EST 2004

Can be a nitemare to get out.
On my 90, which should be almost identiacal,
 There are 2 bolts, on top and underneath the starter... the underneath one
is easy to get to between the subframe and dp iirc, and I think it has a nut
towards the front of the engine.
The upper one is horrible, you need to reach right down the back of the
engine with a 19? Mm spanner, I couldn't get a socket in there ;( there was
no nut on this one.
After that, just tap the motor till it pulls free.

Best Regards,
Alan Pritchard

Network Administrator
Mechanical Design Engineer
Seaeye Marine Ltd.
+44 (0)1329 289000

-----Original Message-----
From: Cat ^. .^ ~ [mailto:iceisit at earthlink.net]
Sent: 02 November 2004 09:54
To: quattro at audifans.com
Subject: 89 Audi 200 Turbo starter

Hi, We got a starter for my 89 Audi 200 Turbo Auto Non-Q and when my hubby
went to put it in he finds he cannot get the old one out . . . . is there a
trick to this or does he need a special tool?   If so, where would be a good
place to get one.   We are in Flagstaff,  AZ, now  :-)    Cheers,  Fay and
quattro mailing list
quattro at audifans.com

More information about the quattro mailing list