the "0" on the flywheel
kneale at coslink.net
Thu Sep 14 14:55:43 EDT 2006
Like the yellow I just rubbed into the "0" grooves in my 200q20v flywheel
exposed for a clutch job?
At 02:10 PM 9/14/2006 -0400, Huw Powell wrote:
>>>The problem with using the vibration damper as a marking point is that
>>>subject to change. The outer rim is separated from the part attached to
>>>the crankshaft by the rubber. So SJ's tricks only apply to one-time
>>>not as a reference for the future.
>> **** Thats correct. One time usage to verify the facts.
>> Chances are very good that this experimental determination of TDC will line
>> up with the Flywheel TDC reference mark, confirming that all is well.
>And as a final note, once having found that flywheel mark, it makes
>sense to clean it, and most people then put a dab of bright colored
>paint in the vicinity to make finding it in the future easier.
More information about the quattro