87 5kCS tranny stuck, won't come out
cody at 5000tq.com
Wed Aug 6 14:09:48 PDT 2014
I was going to say that and forgot! Yeah that's not a bad idea, though I somewhat doubt it's effectiveness over a pry bar. Certainly safer.
-Cody Forbes (mobile)
On Aug 6, 2014, at 3:23 PM, Nick Lawrence <nick at beol.net> wrote:
> As long as all the bolts are out.... would anybody else think about hooking the clutch release back up and stomping on the clutch pedal.... well maybe gently pushing?
> On 8/5/2014 10:37 PM, patrick gillen wrote:
>> I am befuddled. All bolts are out, 2 sets of eyes looked over many times.
>> Everything is disconnected, but trans will not budge. I do recall there are
>> a couple of locating sleeves, but I have never seen these seize up like
>> Anybody have similar issue? Could it be the input shaft stuck to crank
>> pilot bearing? Just kidding only partially here as I can't pry bell housing
>> away from engine a fraction of a mm. I am get ready to cum-along it but thot
>> I'd ask first.
>> Patrick Gillen
>> 503-704-9156 c
>> quattro mailing list
> quattro mailing list
More information about the quattro