[s-cars] Re: Timing Belt Question
irautenberg at comcast.net
Sun May 15 10:21:46 EDT 2005
Hmm. Yes, I remember writing that a few years back (I was doing the TB on
the 200 and thinking about the Urq). I can't say definitively (my '91
200q20v has the 3B motor). However, I have copied-in the S-Car list -- I'm
sure someone here may be able to help further. Otherwise, a good source for
the tinkerers among us is motorgeek.com.
----- Original Message -----
From: "Steven Pagano" <paganois at optonline.net>
To: <irautenberg at comcast.net>
Sent: Saturday, May 14, 2005 3:10 PM
Subject: Timing Belt Question
> I found your email address via this link:
> I am in the middle of building an ABF motor utilizing a VW 2.0l (ABA)
> block with a 16v (9A) head. The issue with this motor is the timing
> belt. In the ideal world, an ABF timing belt is used, which, is 151
> tooth, 25mm wide. People are cramming on 1.8T timing belts which are
> 150 tooth, 25mm wide. In an effort to do this properly, and not blow
> upwards of $50 on a simple belt, I ran a search in google and your
> response popped up.
> You state that the AAN Timing belt for a UrS4 is 151 tooth. Can you
> confirm this statement, and if possible, measure the width of the belt
> in either inches or millimeters?
> I appreciate your time.
> Steve Pagano
> VWVortex: Pagano
> AIM: PGDubbin
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.11.10 - Release Date: 5/13/2005
More information about the S-CAR-List