[s-cars] installation of 034 updated RS2 injectors

Young, Steve sryoung at trane.com
Sat Sep 12 15:32:18 PDT 2009

When I installed mine, I had the same issue.  I called Javad, and he
said the injectors can't go anywhere so the retaining clips aren't
needed.  I looked over the scenario, and concluded he was right, as long
as the fuel rail stays bolted down.  I suppose if the fuel rail comes
loose, you have bigger problems than missing retaining clips.  I would
have preferred having the retaining clips re-installed since they were
there from the factory, but had no issues without them.  


Steven Young
Project Developer - New York / Vermont / Connecticut Territory
301 Old Niskayuna Rd., Latham, NY  12110
Tel: 518.724.1453
Fax: 518.785.4359


P Please consider the environment before printing this e-mail

-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of Steve Marinello
Sent: Saturday, September 12, 2009 5:38 PM
To: s-car-list at audifans.com
Subject: [s-cars] installation of 034 updated RS2 injectors

So, I was installing the injectors just now and realized that the
retaining clips from the old injectors will not work.  Did those of you
who installed these just leave the clips off and rely on the two Allen
screws holding the fuel rail on, or did you source some 'taller' clips?




S-CAR-List mailing list

The information contained in this message is privileged and intended only for the recipients named. If the reader is not a representative of the intended recipient, any review, dissemination or copying of this message or the information it contains is prohibited. If you have received this message in error, please immediately notify the sender, and delete the original message and attachments.

More information about the S-CAR-List mailing list