[urq] Throttle Body Shaft Linkage swap
a.sigal at bluewin.ch
Fri Jul 20 13:57:55 EDT 2007
No BTDT, but in essence you are going to end up with shorter shaft with
slot for TPS. Wouldn't be easier to cut and file the shaft to suit, than
to remove butterfly and all that. Even if it fails, you can always do
the swap. BTW, shaft is one piece, and 2 sunk in screws hold the
butterfly. Must clean the shaft before removing, and adjust butterfly
and Locktite the screws after the swap.
Ben Swann wrote:
>I am trying to swap the shaft and certain parts from the later MC-1 throttle
>body to an earlier WX (Ur Quattro) throttle body. This is so I can use the
>later switch(actually TPS) from later models.
>ANY BTDT on removing the shaft? Is the shaft one piece that goes all the way
>through or does it split somewhere? Any diagrams.
More information about the urq