[urq] 200q20v transmission into UrQ

[n-engelbert at terrans.net]

The transmission is in the car.  I didn't clock the shifter ball on the
20v transmission, though, as I had already removed the arm from the UrQ
transmission.  This makes 2, 4, and Reverse impossible to get into.  While
I was in there, I replaced the bushing in the shift rod, and I tried to
get to the ones on the dogbone piece, but I had a heck of a time removing
them from a sacrificial dogbone piece, so the stock bushings are still in
there.  The ball on the UrQ shifter ball piece was very sloppy in its cast
housing piece, so I stayed with the 200's piece, as the part numbers cast
into the part were the same, and I moved the shift rod over.

So, the engine goes in sometime later this week or this weekend, and I'll
get the shifter aligned then.

As a side note, the little ball that the dogbone piece goes onto on the
transmission needs to be moved on the 200 transmission for the UrQ linkage
to work.  There is a threaded hole about 6" forward of the stock 200 point
that the ball needs to move to.

As for the S6, I love it.  Thanks again for checking it out for me before
I flew out there for the purchase.

Nathan Engelbert
83 UrQ DA900453
89 90q
91 200q20v avant (wrecked)
95 S6 avant


> Sorry can't help on the question - but glad to see you are making
> progress.
>
> So hows the S6 treating you- hope it was a good buy
>
> Brandon
>
> -----Original Message-----
> From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On
> Behalf Of n-engelbert at terrans.net
> Sent: Friday, August 31, 2007 1:35 PM
> To: urq at audifans.com
> Subject: [urq] 200q20v transmission into UrQ
>
>
> OK, I'm in the process of putting my 200q20v transmission into my 3B'd
> UrQ project, and I've moved over the speedo drive gear, but I've got a
> question about the shift linkage.
>
> The large shifter rod attached to the left side of the transmission on
> the 20v and the UrQ are different part numbers. Do I need to swap the
> rod from my UrQ's 016 over to the 20v transmission, or should the rod
> from the shifter of the the UrQ mate right up to the 20v transmission's
> current part?
>
> Thanks!
>
> Nathan Engelbert
> 83 UrQ DA900453
> 89 90q
> 91 200q20v (wrecked)
> 95 S6 avant
>
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection:
> http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
> contributions welcome!
>
>