[urq] fuel tank hose
benswann at verizon.net
Mon Jul 14 19:20:20 PDT 2008
You definitely won't be doing this with a full tank of gas. Best bet would be to pull
the tank and install them on the tank and feed them down.
I've been able to drain into four 5 gallon tanks in order to work on the lines - just
make sure you have room to manipulate the tanks from underneath the car - can be tricky.
[Date: Sun, 13 Jul 2008 15:37:55 -0700
From: "urq" <urq at pacbell.net>
Subject: Re: [urq] fuel tank hose
To: <urq at audifans.com>
Content-Type: text/plain; charset="iso-8859-1"
... if you have an empty fuel tank it isn't too difficult ...
Unfortunately for me the hose went bad right after I filled up with the "new" gas ...
and it was a real PITA to crawl under the car and replace the hose ...
If you only have a small amount of gas in the tank you can plan to drain the tank before
fully removing the hose ...
San Jos?, CA (USA)
Date: Sun, 13 Jul 2008 11:55:20 -0700 (PDT)
From: Gary Brown <gmbchef at sbcglobal.net>
Subject: [urq] fuel tank hose
To: urq at audifans.com
Message-ID: <229458.25907.qm at web82104.mail.mud.yahoo.com>
Content-Type: text/plain; charset=iso-8859-1
How difficult a job is it to replace the hose from the fuel tank to the pre-pump
Can I just remove the grommet where the two hoses go through the floor to the tank? I
see from the FA that they both are attached by hose clamps and nipples.
More information about the urq