[urq] Bringing her home!

[urq]

I used the standard panel and cut holes for two gauges in it.  For a
charging system status indicator I bought a 3-LED charging system tester and
mounted it underneath the diff lock switch.  The lock lights are mounted
above the switch.  Since the cool graphics are gone I have to remember that
the left light is center and the right is rear.  Oh, yes, I also added the
extra vacuum lines and the 3-detent vacuum switch, so it has center or both
diffs locked capability.  

I scanned in a picture of my console and stored it at the yahoo group .... a
link to the group is at the bottom of every post ... 

Fortunately, Audi was still selling the blank panel when I did this ... so I
still have the original panel from the car ... I also have a replacement
graphic appliqué ... 

Steve B
San Jose, CA (USA)

-----Original Message-----


I agree here, pretty plug and play for the I 5,  You don't have to move the
diff lock panel if your resourceful, I can send you a picture.

Mike

 


> From: "Brandon Rogers" <brogers at terrix.com>
> Subject: Re: [urq] Bringing her home!
> Here are my thoughts 
> For gauges I like the factory 3-gauge panel from a CGT - but again then
you
> have to move the diff lock panel...