[urq] Need to Get a Specific Electronic Speed Signal From an UrQ Speedo......

[urq]

... should be pretty easy ... the instrument cluster usually creates one for
the cruise control.  ISTR that on the analog urq dash there's a little 2 pin
connector on the back of the speedo ... that's your electronic speed signal
... 

Steve B
San Jose, CA (USA)

-----Original Message-----

I have a slight spin on this one.  Is there a way to get a speed  
signal while retaining the speedo cable?  I have a stock dash, but  
need a speed signal to feed my PLX R-500 datalogger.  It needs a  
pulsed input for vehicle speed. The stock electronic sender goes in  
the same spot as the cable.  Is there any other place to get a signal?

Eric