[urq] sway bar bushings ?

Louis-Alain Richard larichard at plguide.com
Tue May 5 08:28:44 PDT 2009


I think the bushings comes in many parts, steel inner tube, 2 washers and
the rubber bit. Press the rubber bit into the hole (use liquid soap as a
lubricant), push the tube into it, insert the link with washers, tighten the
nut. That's it.

I did Eric's 1985 urQ sway bar bushings with hand tools, while under the
car, in my driveway. So it's doable by anyone, very easy. MUCH easier than
the early-1983 setup.


-----Message d'origine-----
Also, on the later bar setup with the heim links, is the bushing that
attaches to the control arm pressed in ??? or can a mere shade tree guy do
the job?
thanks in advance,

More information about the urq mailing list