[V8] O2 sensor R&R Problem

Kent McLean kentmclean at mindspring.com
Sun Nov 13 15:46:41 EST 2005

Joe Griffith wrote:
 > I tried to fix a surging on my new to me '91V8Q by replacing
 > the O2 sensor this morning but ran into a little bit of a
 > problem. While I was trying to disconnect the single black
 > wire with the spade connection, I broke off the connection
 > at the motor. ie the male end of the connection.

There is nothing special about the connection, although
I have read that some O2 sensor need "air" in the braided
wiring so the sensor has something to compare to.

You should be able to replace the space connection with
another. Pull back the wire to give yourself some working
space. Either solder the new connector to the old wire,
or use a good *ratcheting* crimper to crimp it.  I got
mine from MCM: http://www.mcmelectronics.com, part number

On a side note, if the wiring was that weak, the old O2
sensor may be/have been OK, and the failure was the at

Kent McLean
'94 100 S Avant, "Moody"
'89 200 TQ, "Bad Puppy" up in smoke

More information about the V8 mailing list