[V8] RPM Sensor

Kneale Brownson kneale at coslink.net
Sun Mar 5 18:57:27 EST 2006

The sensors slide into a housing and are held in place by the bolts that
anchor the heat shield.  I don't think there's any way to "clean" them
without removing the assembly.

You're right that its a PITA.

At 11:28 AM 3/5/2006 -0500, Speakoutprod at aol.com wrote:
>Did you have to replace the sensor or just clean it?  I hear these are  a 
>bitch to replace.  If you just had to clean it, was it still hard to do,  or 
>could a high-pressure hose do the trick?  If I recall, these sensors are  
>underneath the car.
>My RPM sensor is currently acting up ONLY when the car reaches a certain  
>temp (usually on warm days) and once the car has cooled down, the sensor 
>again.  Not particularly good if your car stalls on a railroad track and a  
>train's coming.

More information about the V8 mailing list