[V8] wheel bearings

d saad dsaad at icehouse.net
Wed Jun 20 12:33:17 EDT 2007

That is a pretty expensive tool that you will probably only use once.
To remove the axle, I think you also have  remove the tie rod to
swing the strut out far enough.
At this point, you are three nuts
away from removing the whole strut - why not just do that and have a
machine shop press in the bearings? That is what I did and as I recall, it
was pretty cheap. Bearings, labor, and an alignment were all under $300 -
and I replaced the upper bearing too. 

tlastre01 at sprintpcs.com wrote:  What is a hubshark and where do I get
> _______________________________________________
Audifans V8 mailing list
> Send posts to:
mailto:V8 at audifans.com
> Manage your list connection:
> Have an Audi V8
question?  Check the Audifans Knowledgebase!
> Have a V8 answer?
... Please help others by adding to the KB ... all
> contributions

More information about the V8 mailing list