[V8] Engine Trim
knealeski at sbcglobal.net
Thu Apr 17 11:45:32 PDT 2008
I've used stainless metric threaded rod with wingnuts afixed to the one end. No tools needed to extract them.
Dave Saad <dsaad at icehouse.net> wrote: If you crack off the remaining plastic, you are left with a nice flat
brass surface. I found some big brass slotted head screws and cut
the heads off, then soldered them to the existing screw head. It
could be done so it looked good. I was after functionality, but even
so I think it looks fine. Never have to worry about it cracking off
On Apr 16, 2008, at 11:56 AM, Scott Simmons wrote:
> All of the original screws for the spark-plug-wire covers have broken.
> Dealership prices them at $15, each. Anyone have any home-made ideas
> for tasteful looking bolts to replace them? I just have some metric
> bolts and washers but am thinking of maybe some black allen-head
More information about the V8