[V8] Poor running Audi V8

Tony and Lillie tonyandlillie1 at earthlink.net
Tue Oct 21 18:04:32 PDT 2008

You should have it connected to the car's wiring with the ignition switched 
on. Then, you get a switching signal from 0V to 4.5V on the center wire 
(usually green) while rotating the distributor shaft.


----- Original Message ----- 
Subject: Re: [V8] Poor running Audi V8

I did check with an ohmmeter today but didn't got any reading, does it
have to be connected to the cars wiring
while testing?


urq skrev:
> You can do a basic check with an ohmmeter.  With the dizzy out of the car
> you can power the thing up and verify that the sense output goes from high
> to low as the rotor spins ...

More information about the V8 mailing list