[V8] HID problem...
pjager at jageng.com
Thu Nov 19 16:56:11 PST 2009
If you are not part of the solution
then you are part of the problem
----- Original Message -----
From: <Etdmail at cs.com>
To: <v8 at audifans.com>
Sent: Thursday, November 19, 2009 4:09 PM
Subject: [V8] HID problem...
> I would not cut anything either.
> If you must have these the better kits
> ship with CAN-Bus friendly ballasts..
> From: J B <jb51007 at hotmail.com> writes:
> Hello there from Toronto Can. I have successfully upgraded the european
> headlamps with an HID kit AMAZING DIFFERENCE ! The only problem is it
> triggered the "headlamp bulb" icon in the auto check circuit. Would the
> problem be
> solve as suggested by the old S4 site that showed hot to disable the
> in the relay by cutting thru the solder track? or is there a simpler way?
> Also I could ... match the resistance into the low beam harness but have
> idea what values trigger or keep the circuit happy (lol). Suggestions and
> ideas welcome jb51007 at hotmail.com or 416 300 3721 MUCH thx too
> <kentmclean at comcast.net> writes:
> I wouldn't cut the trace, in case you want to undo it. I believe you can
> put a short jumper wire in place of the relay, disabling the warning.
> Or move the pickup points so the warning still works:
> That's all I "know".
> <ingo.rautenberg at gmail.com> writes:
> Subject: Re: [V8] HID problem
> I also wrote this one waaay back in '97 for the V8:
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> You can help keep the audifans site running by shopping at
More information about the V8