[Vwdiesel] 1985 1.6TD Jetta recently acquired
mikitka at earthlink.net
Tue Nov 28 21:04:01 EST 2006
That all sounds about right. You put the correct oil in there and my I ask
what oil filter? Just curious, Fram isn't recommended. I run Mann/Mahle
filters. As for running a non diesel oil, it depends on how long a drain
interval he ran. If it was only 2k to 3k then it shouldn't have caused any
problems that I can see.
Sounds like you got yourself a deal. Where in NC are you located? I'm around
Goldsboro area a little town called Faison.
Not sure if retorqing the head bolts is a good idea but others on here would
know more on that. If they have been torqued at the 600km/1000mile range I
don't know if retorqing would be wise.
The timing belt if it were mine and not sure of miles on it I would replace
it. At least you then can start from the beginning in that area. Cheap piece
of mine to me.
dear all, sorry if this is a bit long winded but please bear with me.
I've been going over the archives and finding very helpful guidance and
information from the many contributors who post on this list, my thanks
to you all for sharing, this list is a great resource for anyone with a
diesel vehicle, be it a VW or not.
First, a little background on the car and new owner thereof.
I had been looking to buy a VW diesel vehicle for several years off and
on, but, up until recently I never had the money at the same time that I
had found a fixer-upper - I've owned 7 volkswagens previous to the Jetta
and, being a do-it-yourself kinda guy, I've always done most of the
repairs to them and all the maintenance.
The story on the car, a short summary:
It has 190k miles, it had been parked for a few years in the previous
owner's driveway. I'm told that the engine was rebuilt for a cost of
about $1,300 , but the owner didn't keep any of the receipts or know for
sure what all had been replaced, other than rings and bearings. It
supposedly developed a slight exhaust leak after about 2,000 miles that
the rebuilder 'couldn't hear' and so wouldn't fix. The PO said that he
had the rebuild done because it had started smoking and sooting up the
rear of the vehicle. It has great tires, body is in fair condition, no
rust, asking price was $600. How could I resist?
When I got it home and found that there were only 3 nuts left loosely
holding the manifold to the head, I began to have doubts about anything
the PO had told me - Slight exhaust leak , righhtt.
Anyway, I pulled the glow plugs and squirted some oil into each cylinder
and let it soak for a couple days, then changed the crankcase oil and
cranked the engine over till I was sure oil was getting everywhere. I
replaced the glow plugs, then disassembled as needed to put new locking
nuts and gaskets on the exhaust manifold. Upon reassembly, and once I
finally got the IP primed it started up without too much trouble, and
it sounds OK to me (but what the bleep do I know?). So far I've only
driven it just a bit on a steep road near my place and it seems to have
plenty of power, and it starts right up at 30 degrees F (the coldest
it's been so far); I have a few concerns that prevent me from having
the confidence to make it my daily driver at this point, so I was
hoping someone here might be able to give me a few answers.
1). I found a half container of Valvoline 10W-30 oil in the trunk, it's
a non-diesel rated oil;
if this is what the PO was running in the engine for its first 2,000
miles, is there any thing that could or should be done to correct any
problems that may have caused? ( I changed the filter and put in some
Shell Rotella 15W-40)
2). Since I don't know whether the head was ever re-torqued, would it
be wise to do so before I start putting any miles on it? Could I
possibly cause any problems by doing so?
3). Judging from the reading I've been doing, the timing belt seems to
be properly tensioned, and
doesn't seem to be showing any overt signs of impending failure, is it
possible that the belt could
have 'plenty of life left in it', assuming that it was replaced during
the rebuild? I guess there's no way to tell for sure, but thought I'd
ask in case there actually is a way.
If you got this far, thanks for listening, and thanks in advance for any
insights / advice any of you may have to offer.
Mike, in NC
Vwdiesel mailing list
Vwdiesel at vwfans.com
More information about the Vwdiesel