[200q20v] Re: Fuel Regulator

George Sidman sidman at montereynet.net
Fri Oct 5 19:28:59 EDT 2001

BTDT about a year ago.  Not a fun job, but do-able without
removing the fuel rail. The hose connector to the banjo
fitting goes bad, and the only fix is replacement. The new
regulator and hose assembly snakes very neatly into place.
When you remove the old regulator you will probably destroy
the two rubber mounts, so you will need those as well. As I
recall, this job is made easier by removing the nearby
grounding plate, to allow access to the regulator. Those
ground connectors could probably use a good cleaning anyway.
A new vacuum hose is very easily installed during this
project as well.

George Sidman, President
Monterey Network Center
sidman at montereynet.net
831. 657. 1500

More information about the 200q20v mailing list