[200q20v] Thanks to all from newbie that still needs help

DanMurphy1 at aol.com DanMurphy1 at aol.com
Sun Oct 21 22:05:16 EDT 2001

What a great list, many thanks to all that responded to my previous post.
Did a major going over on the the 91 200tq. but still have a low boost 
The timing belt etc.  new plug wires, plugs, cap, and rotor all went on 
without a hitch.
New hoses, belts, valve cover gasket
New bypass valve, vacume lines, temp sender, pull and checked all hoses etc.
Pulled codes and none are recorded, did output test, everthing works as 
should, except I still am getting only 1.6-bar of boost. 

Pinch off lower wastgate hose and instantly get 1.9bar in every gear?
Should I just try a new wastgate solenoid valve, even though it checks out ok 
using the output test?
I have no clue where to go from here.
Any advice on the tiny hose clamps, found the braided line, but no luck on 
the tiny screw down clamps at the three intake tubes.
I am also worried about the rotor button, could not find THE replacement with 
the narrow tip, can i cut one down to size?
ps ,trying to find out how to post the correct way.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.audifans.com/pipermail/200q20v/attachments/20011021/41beebd2/attachment.htm

More information about the 200q20v mailing list