ABS warning light - A4 (B6)

Grant Lenahan glenahan at vfemail.net
Tue Apr 13 09:29:22 PDT 2010

it seems very coincidental with your brake work. So i would begin looking at sensors, dirt on them, wires, etc.  If the abs sensors are not working, you'll get that ( i think)

On Apr 13, 2010, at 11:49 AM, Arthur Marks wrote:

> I did my brake pads and replaced a cv axle, and after the job the ABS and 
> ESP light is on and brake warning light is blinking. Tried to clear the one 
> error code and it comes back immediately:
>   Vag-com (http://www.ross-tech.com)
>     Control Module Part Number: 8E0 614 517 H
>       Component and/or Version: ABS/ESP allrad      2328
>                     Software Coding: 04277
>                     Work Shop Code: WSC 06435
>   1 Fault Found:
>   01435 - Brake Pressure Sensor 1 (G201)
>        57-00 - Electric Circuit Failure
> The brakes work fine though I haven't done a hard stop to test the ABS. Any 
> ideas? The new pads seem to have the proper plug for the wear sensor, and 
> the new axle has the notches for the ABS.
> I notice readings of 291.32 bar for brake pressure readings in the measuring 
> blocks which must be wrong.
> Thanks,
> --Art 
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information

Grant Lenahan
glenahan at vfemail.net

More information about the quattro mailing list