[Vwdiesel] Tie rods/wheel bearings on a Mk2 Jetta

LBaird119 at aol.com LBaird119 at aol.com
Wed Jun 2 10:50:28 PDT 2010

  Cheaper to beat out the old bearing and buy a new bearing and 
hub and drive them in yourself.  Assembly can be done in a vise 
with a couple large sockets, or even just a hammer and something 
to drive the bearing in with (all thread and some nuts and washers 
  Then each bearing and new hub (to avoid pulling the race off of 
the old one) would run  about $40 to $50.

More information about the Vwdiesel mailing list