[Vwdiesel] Injection pump bracket removal and installation and alignment check

Bryan Belman dieselwesty at yahoo.com
Tue Aug 12 09:37:36 PDT 2014

Agree with Andrew, put strait edge across pump pulley and cam pulley to get the proper injection pump bracket alignment and test.
Assuming you have your valve cover off, do you have the proper steps to set timing?
Or, are you beyond that now.
I have a good write -up on setting belt to TDC and then doing pump timing.

Bryan Belman, Pt. Pleasant, NJ
04 Jetta Wagon TDI PD BEW, 100hp, 5sp -- running :<)
04 Golf TDI PD BEW, 100hp, 5sp Tiptronic Auto -- running :<)
82 Diesel Westy 1.9NA 1Y -- running :<)
70 Type 1 Beetle -- Under Restoration forever:-) 

On Tuesday, August 12, 2014 11:50 AM, Andrew .Libby <libbybapa at gmail.com> wrote:

I have found that the sprockets rarely (never?) line up with a straightedge
and trying to get them to does not help with belt tracking.  In fact, I've
found that in order to track correctly, the injection pump sprocket usually
needs to be angled down relative the cam sprocket...   Regardless, whenever
the bracket is removed and reinstalled, the tracking should be checked and
adjusted as necessary so that the belt rides near the middle of the
injection pump.  To get the belt to track closer to the engine, rotate the
pump bracket parts so that the sprocket end of the pump rotates DOWN and
the end with the injection lines rotates UP.  Tighten all the bolts,
insteall the pump, install the belt with it in the center of the sprockets
and rotate it through a dozen revs or so to see if it is wandering.  If it
does, then adjust as necessary.  If it stays centered then torque
everything down properly.

On Tue, Aug 12, 2014 at 8:03 AM, ken1 <ktzkarz at embarqmail.com> wrote:

> Found a post by Bryan stating that if the pump bracket had been removed,
> then use a straight edge on the pump pulley to the front of the head to
> sure the bracket is aligned, then tighten your pump bracket bolts to the
> block Then install your timing belt. The cam pulley and the pump sprocket
> line up and when I try to align with the head, I do not seem to line up
> with the head. Bryan, do you have a picture or reference picture of how you
> do that? ken
> --
> 1982 caddy 1.6L NA running
> 1967 convertible bug running
> 1980 caddy project
> 1991 2 door Jetta TD restoration in progress
> _______________________________________________
> Vwdiesel mailing list
> Vwdiesel at vwfans.com
> http://www.audifans.com/mailman/listinfo/vwdiesel

Vwdiesel mailing list
Vwdiesel at vwfans.com

More information about the Vwdiesel mailing list