[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
> From: "JoMi " <JoMi@msn.com>
> Anyone had any luck trying to splice in a new piece in the larger diameter
> end? The small end and the 'T' fitting are okay - just bad from the 'T' to the
> large end. This is really turning out to be quite expensive what with having
> to also replace the turbo water pump for ~$200 just because the plastic head
> is shot.
If the bottom end is shot, you have a problem. The radius of the
turn is critical or the hose runs right into a unit mounted above it.
I think one could easily make an adaptor for the smaller end of the
hose, but not for the larger end - because of the turn.
Those prices sound really high...for my 1990 200, the hose was $48
Al Powell Voice: 409/845-2807
107 Reed McDonald Bldg. Fax: 409/862-1202
College Station, TX 77843 Email: firstname.lastname@example.org
W3 page - http://agcomwww.tamu.edu/agcom/satellit/alpage.htm
"Baseball is 90 percent mental. The other half is physical"...