[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

amend the intake nozzle elbow mod

A few days ago I posted how to get better bottom end by substituting the
stock, Audi intake elbow with a HomeDepot 90 degree elbow. 

I went back and the prices were raised by about $2. They are now in the $8
range. They are 2" to 2" 90 plumbing elbows. You will have to boil the
intake knee (metal pipe) end to get it to stretch and slip over. Other
than that, no trouble and a noticeable boost to bottom end. Very cheap
alternative to the audi hose and no ports to leak. You'll reroute them to
the intake boot. Handles heat and engine mov't alot better than the
factory hose and wide clamps are included. If you need further
instructions, email privately with this topic.

*Steve                                             Sachelle Babbar
*'87  5000CS Turbo 5spd 1.3-2.0 bar             <SBABBAR@IRIS.NYIT.EDU>
*Cockpit adjustable wastegate, AudiSport badge
*Disclaimer:"Any information contained herein is based purely on my own
*personal experience and may not necessarily reflect yours. Use caution as
*your results may vary from mine."