[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: O2 wrench size info needed...

In a message dated 96-06-02 22:07:29 EDT, you write:

>It is 22mm.  
>On the '88 90Q, an open/box wrench works fine.  You can 
>remove the wiring harness from the connector on top of the engine, 
>and feed it back over the transmission.  There are two clips that can 
>be rem

Or a standard 7/8 will work too.....   Nice if you want the Snap on guy to
sell you the slotted O2 sensor socket or the claw, both very helpful...