SUCCESS with the crankshaft pulley!!

[Max <mpalmars@axxsys.com>]

Just spent three hours replacing the belt.  Most of the reply's I got on
my question " How to remove crankshaft pulley without special tool?" had
to do with bolting the flywheel through a hole on the side of the bell.
However as my car is an automatic there was no hole in the flywheel to
put a bolt into.  Instead I was able to but a crowbar through one of the
openings on the bell and jam it against one of the torque plate mounts
without ruining it, thus jamming the crank shaft.  The rest was easy.
The car runs a little better, but I still have to take a look at the
valve shims and the injectors to get it to run smoothly.

MAX. :-))